Furuno FAR-3230S-BB, Installation Manual

Page: 37 / 139

2. WIRING
2-9
• Antenna cable:
Power: TB801 on RF-TB Board (03P9570)
LAN: J821 on RF-TB board
Shields: For the power cable,
screw on RF-TB Board (03P9570).
For the LAN cable, screw near the
LAN slot.
For the antenna cable RW-9600,
connect the crimp-on lug (that
binds unused wires) together with
the shield of the power cable.
• Cable for sub monitor:
Remove (or Loosen) four
bolts shown in the right figure
to remove the RF-TB board
from the RF unit.
Signal: TB803 on RF-TB board
Coax. cable: TB804 on RF-TB board
Shield: Screw on chassis.
17. Reconnect the performance monitor connector (J807), see step 2 on page 2-5.
18. Check that the gasket on the rear cover is seated properly, then close the covers.
The torque must be 21.0 N•m.
Wire
How to connect wires to WAGO connector
Press downward.
Terminal
opener
WAGO
connector
Twist
<Procedure>
1. Twist the cores.
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is secure.
1 3 6 7 8 9 11 2 4 5 10
BRN RED ORG YEL GRN BLU PPL WHT
Pin
Color
TB801 TB801
Grounding point for
Power cable Grounding point for
Power cable
Grounding point
for LAN cable Grounding point
for LAN cable
Loosen Loosen
Remove Remove
TB804 TB804
TB803 TB803
1 3 6 7 8 9 11 12 13 14 15 16 2 4 5 10
BRN RED ORG YEL BLK WHT
Pin
Color
How to fasten the coaxial cable
NOTICE
Do not use crimp-on lug, to
prevent contact resistance
from increasing.
Fasten conductor with screw. Fasten conductor with screw.
Fasten shield with clamp. Fasten shield with clamp.
Pass through
the locking
wire saddle. Pass through
the locking
wire saddle.