Furuno FAR-3230S-BB, Installation Manual

Page: 34 / 139

2. WIRING
2-6
6. Unfasten the cable gland for
the antenna cable (RW-
00135) and remove the gas-
ket and three flat washers.
7. Slide the cable gland,
the gasket and three
flat washers onto the
cable as shown in the
right figure.
8. Push the flat washer
against the armor.
9. Trim the armor so that
it does not extend past
the flat washers, then
pass the antenna ca-
ble through the cable
entrance.
10. If applicable, also pass the cable for the sub
monitor and the power cable for the deicer
through the cable entrance. Pass the cables
through their respective locking wire saddle.
11. Tighten the cable glands with the hook
spanner wrench.
Note: Use the wrench of the correct size. If
you do not have the hook spanner wrench,
contact our dealer.
12. Pull the cables out of the chassis other than the cable for de-icer. See step 13 for
the deicer.
13. DE-ICER INSTALLATION. If the de-icer is not provided, go to step 14 on page 2-
8. See "S-band DE-ICER Kit Installation Instructions", issued separately, for the
de-icer not fitted at the factory.
1) Remove four bolts then spread open the
right and left heater elements on the
front cover.
Note: Lift the elements slightly when
opening so as not hit the elements on the
bolts on the chassis.
Flat washers Flat washers
Gasket Gasket
Gland for
antenna cable Gland for
antenna cable
Sheath Sheath
Cable gland Cable gland Flat washer
Flat washer
Gasket Gasket
Flat washer Flat washer
Trim the armor.
Push the flat washer
against the armor.
Outer sheath Outer sheath
Inner sheath Inner sheath
For Antenna
cable For Antenna
cable
For power
cable of de-icer For power
cable of de-icer
For Sub monitor
cable For Sub monitor
cable