Furuno FAR-2137S, Installation Manual

Page: 69 / 130

4. INSTALLING OPTIONAL EQUIPMENT
4-13
1. Remove the top cover and open the upper part of the processor unit.
DVI-D port
(Connect DVI cable at step 13)
Processor unit
2. Fix the 03P9229A board (RGB-BUFF) with four screws. (See the figure below.)
3. Attach the connector assemblies to J1 and J3 on the 03P9229A board as follows.
J1
：
13-pin connector of the connector assembly 03-2094
J3
：
3-pin connector of the connector assembly 03-2093
4. Attach six sets of spring washers and spacers to the positions shown below.
Spring washer, spacer
03P9229A board
J615 (Connect connector assembies at step 9.)
03P9342 board
J1
J3
J2
J2 (Connect RGB Cable at step 11.)
Processor unit (Lower part)
5. Attach the DVI-RGB conversion board to the location shown in the figure on the next
page.