7
2.
INITIAL SETUP
2.1
Connections
2.1.1
Power Requirement
The requires either 12 VDC or 24 VDC power. The 10/15/20 m cables are
for 12 or 24 VDC, and the 30 m cable is for 24 VDC only. Connect the red cable to the
positive terminal of ship’s battery; the blue cable to the negative terminal. The black
cable is a shielding cable for grounding.
2.1.2
LAN Cable Connection
Connect LAN cable to the multi function display device or Ethernet HUB.
This radar is compatible with the FURUNO Multi Function Displays and software ver-
sion combinations shown below. Combination with other models may not operate
properly.
• TZT9, TZT14 and TZTBB: Version 5.01 or later.
TZTL12F and TZTL15F: Version 5.01 or later.
Turn on the antenna unit and FURUNO Multi Function Display. Initial setup for this an-
tenna must be done on the FURUNO Multi Function Display.
2.2
Initial Setup for NavNet TZtouch
(Model: TZT9/TZT14/TZTBB)
1. Press the
Home
key (or tap the
Home
icon).
2. Select [Menu] on the menu icon bar to open the main menu.
3. Select [Radar].
WARNING
Radio Frequency Radiation Hazard
The radar antenna sends the electromagnetic radio frequency (RF) energy. This energy
can be dangerous to you, especially your eyes. Do not look at the radiator or near the
antenna when the antenna is rotating.
The distances at which RF radiation levels of 100 W/m
2
, 50 W/m
2
and 10 W/m
2
exist are
shown in the table.
Note:
If the antenna unit is installed at a close distance in front of the wheel house,
prevent the transmission in that area to protect passengers and crew from microwave
radiation. Set the [Sector Blanks] in the [System] menu.
Distance to 100 W/m2 point
Distance to 50 W/m2 point
Distance to 10 W/m2 point
Worst case 85 cm
