Furuno BBDS1, Operator'S Manual

Page: 25 / 40

16
3. INITIAL SETTINGS, OPERATION
After connecting the NavNet equipment, select the transmission power from the NavNet equip-
ment startup wizard. Refer to the respective Instruction Manual.
3.1 MODE SW
The MODE switch provides the functions described in the table below. Remove the rubber cap to
access the switch and set switches with a plastic screwdriver or the like.
For NavNet 3D, turn off all switches.
SW No.
Function,
description
Setting content
1
(Default: ON) Power from Navnet
equipment OFF: Sounder powered on/off by NavNet equipment.
ON: Sounder not powered on/off by Navnet equipment.
2
(Default: OFF) IP number
(Currently no use) OFF: IP0
ON: IP1
Note: When installing the below-mentioned units to a
NavNet network other than the NavNet 3D network,
turn the 1st unit OFF and the 2nd unit ON.
• BBDS1, 2 units
• DFF1, 2 units
• BBDS1, 1 unit, DFF1, 1 unit (total of 2 units)
3
(Default: OFF) Factory testing OFF: Testing OFF ON: Testing ON
4
(Default: ON) Automatic IP setting
(Currently no use) OFF: Automatic IP enabled ON: Automatic IP disabled
NETWORK
MODE SW
1 2 3 4
XDR 12-24 VDC
1.1-0.4 A
1
+
3 GND
ON
1 2 3 4
2
-
ON
1 2 3 4
OFF
NavNet 3D MODE switch settings
ON
1 2 3 4
OFF
NavNet TZtouch/NavNet TZtouch2
MODE switch settings
#1: ON
#2: OFF
#3: OFF
#4: ON ALL
OFF