Furuno 1835, Installation Manual

Page: 29 / 48

3-3
3.3 How to Enter the Initial Settings
After you set the purpose of the radar, enter the initial settings as follows.
1. On the main menu, press
T
or
S
to select [Installation].
2. Press the ENTER key. The Installation menu becomes active and the cursor moves to the
right column.
3. Press T or S to select an item from the [Installation] menu.
4. Press the ENTER key to show the setting window.
5. Press T or S to select an option.
6. Press the ENTER key to validate the setting.
7. Press the MENU key to close the main menu.
Basic Settings
Input Source: Select the input source from [Master] and [Slave]. The default setting is [Master].
Master: A display unit operates as the main radar.
Slave: A display unit operates as a remote display. For the remote display, make sure you
adjust the [Video Init Adjust] and [Timing Adjust] (page 3-5 and 3-6).
ARPA QV Select: Set to [On] position to display quantized video on the screen. Set to [Off] posi-
tion for normal use.
Demo Mode: Set to [On] position to activate the demo mode. Set to [Off] position for normal use.
[ENTER]: Enter [CANCEL/HL OFF]: Back
[MENU]: Exit
System
GPS
Units
Target
ARPA
AIS
Demo Mode
Input Source
ARPA QV Select
Antenna Height
Heading Adjust
: 15m
: 2
: 0. 0 °
: Off
: Master
: Off
MBS Adjust*
Auto Install Setup*
Timing Adjust
Near STC Level
: 0
: 0
: 0.000 NM
Menu Menu
Installation Installation
Initial
Factory
Sector Blank **
Installation
Total On Time* : 000000.5 h
Total TX Time*
: 000000.6 h
* : Displayed when scrolled.
Memory Clear*
** : Set the [Sector Blank] to [Off] in order to
execute [Auto Installation Setup] in the
[Installation] menu.
Video Init Adjust* : 6
ARPA Adjust SP*
: 2
ARPA Adjust MP*
: 2
ARPA Adjust LP*
: 2
Antenna Rotation : Rotate
Tests
A/C Auto Adjust