Furuno 1824C-BB, Installation Manual

Page: 14 / 82

1-4
1.2 Mounting the Processor Unit
The unit can be mounted on the deck, a desktop or on a bulkhead. Select a mounting
location considering the points below.
•
Locate the unit out of direct sunlight.
•
Select a location where temperature and humidity are moderate and stable.
•
Consider the length of the cable connected among the processor unit, antenna unit (or
power supply unit) and control unit.
•
For mounting on a bulkhead, be sure the mounting location is strong enough to support
the unit (4.1kg) under the pitching and rolling normally encountered on the vessel.
•
Leave sufficient space around the unit for maintenance and servicing. Recommended
maintenance space appears in the outline drawing at the back of this manual.
•
A magnetic compass will be affected if the processor unit is placed too close to the
magnetic compass. Observe the compass safe distances in the SAFETY
INSTRUCTIONS to prevent disturbance to the magnetic compass.
Tabletop or deck mounting:
Fasten with four tapping screws.
Bulkhead mounting:
Mark four fixing hole positions on the bulkhead. Screw in two tapping
screws at lower fixing positions, leaving 5 mm protruding. Set the processor unit to the
screws and screw in two tapping screws at upper positions. Tighten all screws.
POWER
310±0.5
375
235 270
250±0.5
7
2-
φ
7 fixing holes
2 fixing holes
DATA 3 NETWORK CONT DATA 1 DATA 2
DJ-1
REMOTE FMD DISPLAY
RGB OUT
NTSC/PAL
2
GND
3
INPUT
12-24 VDC
1
CARD SLOT
3
2
1
GND
F.G.
12 VDC
OUTPUT
OPTION
0.3 A MAX
Processor unit, mounting dimensions