9
9. Connect the SATA cable from the SSD fixture assembly to CN7 on the motherboard assembly.
10. Insert the new DVI connector board (19P1092 (ADP-896-01)) and secure it using the pan head
screws (M3×6). If you removed the VC card, fill the screw hole.
Note
: If the spacers of the DVI connector keep the DVI connector board from being inserted,
remove the spacer then reattach them after inserting the board.
11. Secure the new shield plate, using the four pan head screws (M3×8).
12. Secure the new MB fixture assembly, using the four pan head screws (M3×8).
13. Secure the printed board, which is attached to the cable end of the SSD fixture assembly, to the
MB fixture assembly, using the two pan head screws (M3×8).
CN7
DVI connector board
Fasten the screw
after inserting
the board.
If you removed the
VC card, fasten the
screw to fill the
screw hole.
DVI connector board
Shield plate
Some parts or wiring
have been omitted from
the illustrations for
clarity.
MB fixture
assembly
MB fixture assembly
Secure the board that is attached
to the SSD fixture assembly.
