Furrion FGHWCLDA-BL, Instruction Manual

Page: 10 / 44

10
English
Operation
WARNING
Keep your arms and face away from being directly above
the cooking area while in operating the appliance.
DANGER
●
The top glass cover must be kept open when lighting
and using the cooktop.
●
Do not attempt to light more than one burner at a time.
Lighting the Cooktop
Before lighting, check and make sure all the control knobs
are in the
OFF position. Make sure the main gas tank valve is
opened.
Standard Ignition:
1. Lift to open the cooktop top glass cover. (Fig. 10) The top
glass cover must be kept open when lighting and using the
cooktop.
Fig. 10
2. Push and turn the appropriate burner control knob
counterclockwise to the position. (Fig. 11)
Fig. 11
3. Keep the burner control knob pushed in and turn the
ignition knob clockwise repeatedly until the burner is lit.
(Fig. 12)
Fig. 12
4. Once the cooktop burner is lit, keep the ignition button
pushed in for about 5 seconds until the flame becomes
steady.
5. Rotate the burner control knob to adjust the flame to
desired level.
6. Repeat steps 2 and 5 to light the other burner(s) as
required.
If the burner does not ignite
In the event of failure to light the burner within 5 seconds,
immediately turn the control knob clockwise to the
OFF
position. Wait at least 5 minutes and repeat the igniting
procedure. If ignition still not occur, use a gas lighter or a
match to light the burner. Refer to the ‘
Manual Ignition
’
section.
Manual Ignition:
WARNING
Use care when lighting the burners by hand. If a burner
lights unexpectedly, or your hand is to close to the burner,
you could be burned.
In the event of failure to ignite the burner in standard ignition,
you may light the burner manually by following the steps
below:
1. Turn the appropriate burner control knob
counterclockwise to the position. (Fig. 13)
Fig. 13
2. Immediately strike and place a burning long wooden
match or a gas lighter near the burner to light. (Fig. 14)