8
Installation
English
B. Mounting on a wood stud wall
covered with gypsum board
(drywall)
1. Use a stud finder to firstly find both the
edges of the wooden stud. Locate the
center of each wooden stud and mark the
center lines for two studs.
Note:
Drywall covering the wood stud
wall must not exceed 16 mm (5/8").
2. Place the wall plate paper template
against the wall to ensure the 4 holes line
up with the stud center lines. Level the
wall plate paper template and paste it in
place.
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely
.
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
16 in. (406.4 mm) apart
Drill here for solid concrete or concrete block wall o
nly
Drill here for solid concrete or concrete block wall o
nly
Paper Template
Note:
The mounting hole must be
centered on the stud.
3. Using a 7/32" (5.5mm) drill bit, drill 4 pilot
holes. Then remove the wall mount paper
template from wall.
Note:
Pilot holes must be drilled to a
depth of 3" (75 mm).
Note: This is the drilling template to be pasted
on wall for drilling holes easily and safely
.
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
Drill here
(16" apart)
16 in. (406.4 mm) apart
Drill here for solid concrete or concrete block wall o
nly
Drill here for solid concrete or concrete block wall o
nly
4. Install the wall plate on wall using 4 lag
bolts(A) and washers (B). Tighten the lag
bolts securely so that wall plate is firmly
attached to wall.
Warning:
Do not over tighten.
