Assembly Instructions
Prepare product as per page 2:
Build Timber Frame: Fit Leg frame
You will note that leg frame [2] sit at angle. Stand leg frame as indicated in diagram below, next
with the help of another person aline the cross base as indicated below, insert tongue of timber
into hole on inside of leg frame and aline the lower part of cross base as shown below. Next take
slotted nut [C] insert into hole in top of cross base. Ensure slot is facing up, then take long bolt
with washer [A] insert thru hole in leg frame as shown below. Ensure to seat thread correctly into
slotted nut, use flat tip screw driver to aline bolt and slotted nut as indicated below. Please thread
bolt by hand as you will be able to feel once thread is aligned correctly do not tighten yet.
Next take bolt and washer [B] insert thru hole as indicated below, again fit by hand to ensure bolt
is seated correctly into thread. Once both bolts are seated correctly table tool [D] and tighten both
bolts. Repeat for second Leg Frame. Move to next page.
4
