ASSEMBLY INSTRUCTIONS
Page 8
Assembling Drawer’s Runners (a.k.a. Rails, Glides, Slides or Guides)
An assembly of ONE drawer requires two sets of runners. The runner is composed of
an inner rail and outer slide. Please read completely first before assembling.
Mounting the Inner Rail (Fixed) of the Runner:
Before mounting, please determine
which side of the panel is the front and rear. The single screw hole on the outer slide
MUST be positioned on the FRONT of the panel. Place the inner rail of the runner in
its correct position and flat on its back. Slide the outer slide out to the way to align the
center or second holes on both ends of the inner rail with the pre-drilled holes on the
panel. For most applications, the center or second holes are used but if not, just make
sure the appropriate rail holes are aligned up with the panel holes. Use two screws to
secure the inner rail of the runner onto the panel.
Mounting the Outer Slide (Moveable) of the Runner:
Each outer rail is secured with
a single screw onto the FRONT SIDE of the drawer. Extend the two outer slides of the
runners and place the drawer in between those two outer slides. Align the pre-drilled
holes on each side of the drawer with the screw holes of the outer slides. Use two
screws to secure from the inside of the drawer into the screw holes of the outer slides.
1
2
12
13
O
F
G
5
Screw Hole
2nd Hole
2nd Hole
front
front
outer
outer
inner
Screw Hole
front
5
12
STEP2
Hardware #1 = 4pcs
Hardware #2 = 12pcs
Hardware #4 = 2sets
Hardware #5 = 4pcs
Hardware #12 = 8pcs
Hardware #13 = 8pcs
PLUS
4
4
outer
inner
First remove the inner slide from the outer slide
of the runner
by pushing down on the tab to
completely remove the two parts. Use only the
outer slides for this step.
4
4
Page 5
Align the inner parts of (4)
and insert screws (13).
Align the outer parts of (4)
and insert screws (13).
Align rails (5) to the holes
and insert screws (12).
Insert the wood
dowels (2) into the
holes along the sides.
