Step 5
Page 6 of 6
I.
Prepare a complete bed slat by using 3 slats (#6), two
center plastic connectors (#F) and two end caps (#G).
See diagram below for the correct sequence in connecting
those parts.
II.
Align the end caps (#G) with the pre-drilled holes on each
side of the side rails (#2) and snap both ends to lock in
place. Then snap the two center plastic connectors (#F)
onto the central support rails (#4).
III.
Repeat the above process for the remaining bed slats.
ASSEMBLY IS COMPLETED
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
#F x 26 pcs
#G x 26 pcs
Summary of Contents for CM7060IV-CK
Page 2: ...Page 2 of 6...
