Furniture of America CM7056-CK, Assembly Instructions Manual

Page: 18 / 23

Turn right (clockwise) to tighten
Page 6 of 6
Enlarged
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
I. Align the support rail (#4)
with the pre-drilled holes on
the center of the headboard
(#1) and the footboard (#3).
II. Prepare 4 bolt assemblies by
inserting FIRST the lock
washer (#E) onto the bolt
(#B) and then the flat washer
(#D) onto the SAME bolt
(#B), in that order.
III. Insert the 4 bolt assemblies
through the brackets of the
support rail (#4) using the
Allen wrench (#H) to lock
them in with the headboard
(#1) and the footboard (#3).
I. Prepare a complete bed slat
by inserting one center
plastic connector (#F) onto
the ends of two bed slats
(#6). Then connect two end
caps (#G) onto the other
ends of the bed slats (#6).
II. Align the end caps (#G) with
the pre-drilled holes on
each side of the side rails
(#2) and snap both ends to
lock in place. Then snap
the center plastic connector
(F) onto the central support
rail (#4).
III. Repeat the above process
for the remaining bed slats.
ASSEMBLY IS COMPLETED
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
#F x 14 pcs
#G x 28 pcs