Furniture of America CM7056-CK, Assembly Instructions Manual

Page: 12 / 23

Turn right (clockwise) to tighten
Page 6 of 6
Enlarged
#B x 8 pcs
#D x 8 pcs
#E x 8 pcs
I. Align the two support rails
(#4) with the pre-drilled holes
on the headboard (#1) and
the footboard (#3).
II. Prepare 8 bolt assemblies by
inserting FIRST the lock
washer (#E) onto the bolt
(#B) and then the flat washer
(#D) onto the SAME bolt
(#B), in that order.
III. Insert the 8 bolt assemblies
through the brackets of the
support rails (#4) using the
Allen wrench (#H) to lock
them in with the headboard
(#1) and the footboard (#3).
I. Prepare a completed bed
slat by using 3 slats (#6),
two center connectors (#F)
and two end caps (#G).
See diagram for the correct
sequence in connecting
those parts.
II. Align the end caps (#G) with
the pre-drilled holes on
each side of the side rails
(#2) and snap both ends to
lock in place. Then snap
the two center connectors
(#F) onto the central support
rails (#4).
III. Repeat the above process
for the remaining bed slats.
ASSEMBLY IS COMPLETED
#1
#4
#3
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
#F x 30 pcs
#G x 30 pcs