Page
6
of
6
I.
Align the assembled support rail (#5) with the pre-drilled holes on the center
of the headboard (#1) and the footboard (#3).
II.
Prepare 4 bolt assemblies by inserting FIRST the lock washer (#B) onto the
bolt (#A) and then the flat washer (#C) onto the SAME bolt (#A), in that
order.
III.
Insert the bolt assemblies through the brackets of the support rail (#5) using
the Allen wrench (#F) to lock them with the headboard (#1) and the
footboard (#3).
#A x 4 pcs
#B x 4 pcs
#C x 4 pcs
Turn right (clockwise) to tighten
#D x 13 pcs
#E x 26 pcs
I.
Prepare a bed slat using two slats
(#6), one center connector (#D)
and two end caps (#E). See
diagram for the correct sequence
in connecting those parts.
II.
Align the two end caps (#E) with
the pre-drilled holes on each side
of the side rails (#2) and press
firmly down on both end caps (#E)
to lock with the side rails (#2).
Then press firmly down on the
center connector (#D) to lock with
the support rail (#5).
III.
Repeat the process above to
assemble the remaining bed slats
onto the side rails (#2) and the
support rail (#5).
IV.
Place the 2 cushions (#4) onto the
headboard (#1).
V.
Make sure the bed is rested on a
flat surface and does not feel
loose or wobbly. If it does, double
check that the bolts/screws are
secured and properly tightened.
Note: The correct position of the bed
slats should be arcing UPWARD when
placing on the rails.
ASSEMBLY IS COMPLETED
Adjust the levelers according to
the ground level. To lower or to
raise the slat support legs, turn
the leveler clockwise or
counterclockwise, respectively.
Summary of Contents for CM7017EK
Page 2: ...Page 2 of 6 ...
Page 8: ...Page 2 of 6 ...
