6
Use 4 OR 8 x Part D bolts to
fasten the connecting rods
(Part 3) tightly in place like
in the picture on each end
of the frame. The capacity
for 4 or 8 Part D bolts
depends on the model you
have received, though 4 is
always enough.
Note: The Part D bolts
do not screw in to the
connecting rods, they only
push against the rods to
hold them securely in place.
Parts used: D
5
Turn the desk top upside
down on the ground and
place the desk frame upside
down on top of it. Adjust
the frame to suit the width
of the desk top, making
sure that the centre point
of each Part 3 stays in the
middle (either these will have
a small predrilled point, or
you can mark a centre point
yourself on each).
If you purchased a FURNA frame with 6 x pre-drilled holes you can now fix the desk top to the frame using 6
x Part A bolts, or otherwise drill in 6 x (M5 x 20mm) wood tapping screws which would be supplied separately.
The screws or bolts should go through the holes in Part 4 (the desk top mounting brackets).
