1
If not already inserted into
Parts 2, insert Parts 3 (2 x
Connecting Rods) into the
slots in Part 2 to connect
both sides of the desk
frame. The Connecting
Rods may or may not have
cutout parts as shown in
the picture, and if so they
should be facing inwards
towards the frame.
Note: The small crossbars
on each Part 2 should be
facing down to the ground
as shown by the arrows.
Parts used: 2,3
2
Position Part 1 (legs) and
fasten in place using Parts
A, F and G. This should be
done in 4 places per leg
according to the picture.
Do not fasten tight at this
point, there should be some
small amount of movement
allowed until later in the
assembly.
NOTE: If you drop a bolt
inside the frame (Part 2),
simply slide the rails apart
to retrieve the part.
Parts used: A,F,G
There is a welded bracket
with two screw holes
on the back of each leg.
Make sure they both face
the REAR of the desk.
