10.
Attach the retaining bar
To attach the retaining bar, indentify
the screws on the underneath of the
bed (on the
foot end
), and
remove
these screws
.
11. Slide the
retaining bar
into the
gap between the bed frame and the
top layer of the bed at the foot end
side.
• Put the screws at the foot end
back in and secure the top of the
bed to the frame.
10.
Attach the stiletto metal legs
on
each corner of the bed by using the
30mm screws.
They should be at an angle and face
outwards as shown in this diagram.
11.
Attach the retaining bar
(put to one
side in stage 3).
To attach the retaining bar, indentify the
screws on the underneath of the bed (on
the foot end), and
remove these screws
.
12.
Slide
the retaining bar
into the gap
between the bed frame and the top layer
of the bed at the foot end side.
• Put the screws at the foot end back
in to secure the top of the bed to the
frame.
13.
Prepare
for the electrical connection
instruction.
• Insure that all the wires have the
cable ties removed.
• Do not plug in your new bed until the
next stage is complete.
Position leg here
Position leg here
Slide into
this gap
Controller
Box
3. Connect
the side rails to the head board
sliding the bolts into the bracket and tightening
with socket set.
• Repeat this process
on the other side of
the headboard and the footboard.
PUSH DOWN
5
. Screw the two wooden support blocks
into the Head and Footboard.
A secondary golden wood screw is
required on each to secure in place.
6
. Screw the two further (60mm) wooden
blocks into the two baseboards. These are
pre-drilled for ease.
• Insert the
ottoman baseboards
into
the base unit as shown.
HEAD
FOOT
HEADBO
ARD
/
FOO
TBO
ARD
4
. Screw the
40mm wooden block
into
the the pre-drilled support bar then insert
vertically across the bed between the two
side rails.
• The
support rail
is secured with a slide
on bracket as shown in the diagram.
Please Note:
this step will require two
people and requires lifting.
40mm
60mm
SUPPORT
BLOCK
Remove this
protective sleeve
before fitting
PLEASE NOTE: It may be easier to rotate
the base onto it’s side for this step.
