IT-Reference 7 - Owner’s Manual
- 7 -
line suppressors. Further, our cable and satellite
suppressors are TIVO friendly as well as HD-
Digital Television ready. Both DC carrier signals
as well as high bandwidth signals can pass
through our circuit. In fact the bandwidth is less
than 0.1dB loss at 1GHz!
To connect your cabling to these in-line protectors,
simply follow the in and out indications marked
next to the Cable and or Satellite connectors.
NOTE: It is not possible to make an in-line cable or
satellite protector “maintenance-free” as we have
accomplished with the 120 VAC line. This would
necessitate limited signal bandwidth that would not
allow the signal to pass. Under extreme conditions, it
is possible that the surge suppression in one of these
devices could sacrifice itself after a catastrophic
event. These protection devices are extremely robust
however, and it is unlikely that any damage will occur
unless the connector is physically deformed via a
lightening strike.
W
a r r a n t y
Furman Sound, Inc. warrants to the original
purchaser of this product, the Furman IT-
Reference 7, that the product will be free from
defects in material and workmanship for a period
of five years from the date of purchase. The
purchaser of the product is allowed fifteen days
from the date of purchase to complete warranty
registration by mail or on-line at the Furman
website. If the purchaser fails to complete
the aforementioned registration, the warranty
period will be reduced to one year from the date
of purchase.
If the product does not conform to this Limited
Warranty during the warranty period (as herein
above specified), purchaser shall notify Furman
in writing of the claimed defects. If the defects are
of such type and nature as to be covered by this
warranty, Furman shall authorize the purchaser
to return the product to the Furman factory or to
an authorized Furman repair location. Warranty
claims should be accompanied by a copy of the
original purchase invoice showing the purchase
date; this is not necessary if the Warranty
Registration was completed either by mailing in
the completed warranty card or by registering
on-line at the Furman website. Shipping charges
to the Furman factory or to an authorized repair
location must be prepaid by the purchaser of
the product. Furman shall, at its own expense,
furnish a replacement product or, at Furman’s
option, repair the defective product. Return
shipping charges back to purchaser will be paid
by Furman.
CONNECTED
EQUIPMENT
WARRANTY:
Furman
Sound’s
Connected
Equipment
Warranty covers equipment that is damaged
by transient voltage (an “Occurrence”) while
properly connected through the Furman IT-
Reference 7 to a properly wired AC power line
with a protective ground in an indoor location.
Furman’s Connected Equipment Warranty is
limited to the amount of the deductible on the
Purchaser’s personal property insurance policy
up to $500.00. In order to make a claim for this
Connected Equipment Warranty, the Purchaser
must forward a copy of his/her personal property
insurance claim for the damaged equipment to
Furman and complete the Furman Connected
Equipment Warranty claim form (call Furman
at (707) 763-1010 to obtain the form). Furman
reserves the right to review the damaged Furman
product, the damaged connected equipment,
and the site where the damage occurred. All cost
of shipping damaged equipment to Furman for
inspection shall be borne solely by the Purchaser.
Damaged equipment must remain available
for inspection until the claim is finalized. The
Connected Equipment Warranty is also in effect
for a period of five years unless the Purchaser
does not complete the warranty registration
Summary of Contents for IT-Reference 7
Page 1: ......
