Funktion-one Resolution 1, User Manual

Page: 7 / 17

6
Power
There is no substitute for a good clean amplifier, Funktion One has
extensively searched for good quality high power amplifiers and strongly
recommend Funktion Ones OEM E series Amplifiers, developed from
the specialists at MC
2
.
For two or three pairs of Resolution 1 we recommend using a E25 to
drive the 12” while the 5” are driven by an E15. For passively crossed
Resolution 1 an E25 can drive up to 2 pairs.
System Management
For non passive modules we recommend the use of Funktion Ones
Crossover, designed to maintain signal quality during this sensitive
period. We recommend the output settings to be:
Driver
Delay
(mS) Polarity
Cross
Over Point
(HP)
Cross
Over Type
(HP)
Cross
Over Point
(LP)
Cross
Over Type
(LP)
Relative
Gain
Settings (dB)
12” 1.521 Positive 30Hz 24dB LR 520Hz 24dB LR +3
5” 0 Positive 520Hz 24dB LR 22kHz 24dB LR -6
LR= Linkwitz Riley HP= High Pass LP= Low Pass
When paired with a suitable bass it is recommended to raise the 12”
High Pass cross over point to 70-100Hz, see Pairing with Bass for more
information.
Note: These settings are made under the assumption that the
amplifiers of identical input sensitivity and through gain.
GAINS ARE GIVEN AS A STARTING POINT AND NOT AN ABSOLUTE.
Pairing with Bass
Recommended bass loudspeakers
are Funktion One’s Minibass 212 ,
F118 and the F218 . With the High
Pass cross over point between 70-
100Hz depending on the
application.
Notes: