TRT800A / P/N 800ATC-A-(2xx)-(3xx)
Operation and Installation
34
Document-No: 03.2114.010.71e / Revision: 2.20
4.4.2 Option Remote Header
The transponder provides a TRT800RT remote control interface. If a
remote header TRT800RT is connected transponder can be remote
controlled via this interface. Remote interface provides control of all
standard user inputs available during standard operational mode. For
more information see TRT800RT manual.
Remote control interface de-/activation is setup configurable. Remote
control interface must only be connected to TRT800RT.
4.4.3 Serial Interface (RS232)
Using serial interface a GPS receiver can be connected to broadcast
own position via ADS-B Out position message. Position could be
received by other appropriately equipped aircrafts and processed for
collision avoidance ADS-B Out functionality.
Information to connect an external GPS to the TRT800H
for ADS-B Out:
A GPS receiver can be connected to the serial interface to enable the
transponder to transmit the own position as ADS-B messages.
The serial data line of the GPS receiver is connected to RX (Pin 12,
brown) and Ground (Pin 1,9, blue) of the 15 pin D-SUB connector. These
pins are usually led out as open ends of the wiring harness.
The corresponding setting of data format is described in the manual in
this chapter “Option: Serial interface (RS232)”. The standard setting for
most GPS receivers is NMEA 4800 baud. How to change configuration
settings is described in the manual chapter 4.5.4
Setup
→
4.5.4 Wiring
→
3.7.3
Setup
→
4.5.4 Wiring
→
3.7.3
Summary of Contents for TRT800A-OLED
Page 2: ......
