Fulton Hogan ESTOP, Operation & Service Manual

Page: 17 / 28

NZ eSTOP™ Operations & Service Manual
Fulton Hogan Signs & Graphics | signs@fultonhogan.com | P: 0800 274 463 Page | 17
Fulton Hogan Signs & Graphics | signs@fultonhogan.com | P: 0800 274 463
Page | 15
ƒ‹”‹‰–Š‡‡OP™ Handheld Remote Controller (HRC)–‘Žƒ–‡”—‹–•
The e TOP™ HRC can be paired to any eSTOP™ lantern units. Once a lantern unit is paired to a HRC it
is ste
in memory, they will be automatically synced when powered up and ready for operation.
By default a HRC is paired t 1 lantern unit only. Repairing is t⁴ required unless the HRC is paired
t a different lantern unit, pairing 2 lantern units t 1 HRC, or lantern s have been mixed up and do
t⁴ know which lantern is paired.
It is recommended to bei n pairing by un-pairing all lante n units from the HRC, this will reduce
confus on abt⁴ which lante n unit if alre dy paired previous y. Follow the ste s be ow to bei n the
process.
Power on the HRC and the Lantern units, these must be in test mode for pairing (status
blue on button
❿ )
Un-pairing eSTOP™ units
Un-pairing is required if the HRC is already paired to an unknown lante n and unable to sync.
To do t is the HRC
must be in test mode (status light is blue, t e USB port must be
disconnected from t e e TOP™ unit. Press and hold Unit “Go” butt n ❻ for 5 seconds
until a beep sounds. T e HRC will flash a red light on the
Status Indicator,
te n
Fault1
indicator will be blank, this indicates no lantern unit is paired t unit on HRC.
Repe t this un-pairing process (using Unit2 “Go” button) to un-paire Unit2 (le t s de of the
HRC) if a sen d lante n is paired to Unit2 s de. Afte un-pairing,
Fault1 and Fault2 indicator
will be blank, where no LED is on.
Pairing eSTOP™ HRC Unit1 (Left side of the HRC)
1. When in test mode attach the micro USB cable from the
t⁰ of te HRC unit t te USB conne tr on the se of the
eOP ™ l antern unit, show n on the image.
2. ess and hold Unit1 GO button ❻ for at least 4 seconds until a beep ss.‮ Ts single beep
indicates pairing has initiated and the button can be released.
When the pairing process is complete the HRC will sound either a st double beep as well as
a g reen flashing lit⁴ on te Status Indicator or a long single beep with a red light on the Status
Indicator .

A st double beep and green light indicates successful pairing. Fault1 indicator will go blue
once it’s paired and changed to green when synced (wireless communication between HRC
and
the lantern is established) t the paired unit.