Full Boar FBWDV-40PTU, Instruction Manual

Page: 6 / 11

10 11
KNOW YOUR PRODUCT KNOW YOUR PRODUCT
Fitting the motor head (12):
1.
The motor head (12) is fastened to the tank (8) by the
motor securing clips (6), (fig. 7).
2. To remove the motor head (12), open the securing clips
(6), (fig. 8) and lift the motor head (12) by the carry handle
(2).
3.
When fitting the motor head (12), make sure that the securing clips (6) lock
into place correctly.
Fitting the filter
Fitting the foam filter (27) - vacuuming liquid:
1.
For wet vacuuming, slip the supplied foam filter (27) over
the filter cage (13), (fig. 9).
Note. The pleated filter (24), already fitted upon delivery is
not suitable for wet vacuuming.
Fitting the pleated filter (24) - vacuuming dry matter:
1.
For dry vacuum cleaning always use the pleated filter. If it is not fitted, slip it over the
filter cage (13), (fig. 10). Place the cap (25) on the base of the pleated filter (24), turn in a
clockwise direction to lock in position (fig. 11). The pleated filter (24) is suitable for
dry-vacuuming only.
Note:
Do not use the
foam
filter (27) when vacuuming
dry mater.
ASSEMBLY (cont.) ASSEMBLY (cont.)
Fig. 8
Fig. 9
Fig. 10
IMPORTANT! Never use the wet and dry vacuum cleaner without a filter. Check
that the filter is securely fitted at all times.
Fig. 7
Fig. 11
Fitting the dust bag (26) - vacuuming dry matter:
Place the dust bag (26) inside the tank (8), then slip the
opening over the vacuum inlet, (fig. 12).
Fitting the suction hose (33):
Connect the suction hose (33) to the corresponding connector on the wet and dry vacuum
cleaner, depending on the application required.
Vacuuming
Connect the suction hose (33) to the suction hose connector
(7), (fig. 13).
Blowing
Connect the suction hose (33) to the blow
connector (15), (fig. 14).
Air regulator (23):
The air regulator (23) on the tube handle (18) can be fitted
between the suction hose (33) and the suction tube (17),
(fig. 15). The suction power of the nozzle can be adjusted by
using the air regulator (23).
When wet vacuuming, make selective use of the air regulator
to suck in air as well as liquids. This will help to take some
strain off the equipment when vacuuming liquids.
Fig. 15
Fig. 12
Fig. 13
Fig. 14