17
Replacing V-belt(s) fig. 14 & 15
Only fit A725 V-belts to this plate compactor. This type of V-belt is available as a
common spare part. Both V-belts should be replaced at the same time because
they will wear evenly through normal use. Work on one belt at a time.
1.
Loosen the lock nuts B and bolts A shown in above figure (fig. 15).
2.
Loose 4 engine mount bolts (do not remove) only enough to move the engine
forward.
3.
Slide the engine toward the front of plate and slip the old V-belt(s) off of the
pulley and install the new V-belt(s) in their place.
4.
Position the V-belt(s) over the engine pulley.
5.
Move the engine back.
6.
Check the V-belt tension by squeezing them in the centre. The normal
deflection on each side should be 9mm (3/8”) to 13mm (1/2”) with moderate
pressure from your thumb or finger.
7.
When the V-belt tension is correct, tighten the engine mount bolts and the
lock nuts B.
8.
Replace the belt guard.
WARNING!
When adjusting the belt(s), make sure that the clutch pulley is
in alignment with exciter pulley.
WARNING!
When removing or installing the drive belt(s), be careful not
to get your fingers caught between the belt and pulley.
MAINTENANCE (cont.)
