UNLOCKING THE BALANCE
1.
Be sure the small operating knob in the lower front center of the base is turned
clockwise to lock the balance. Lay the balance on its back and loosen the two
knurled shipping arrest knobs (A) under the base (shown in figure 1). Do not
touch the screw in the center of the knobs. Merely loosen the knobs slightly, push
them as far as possible towards the ends of the balance, and tighten them again as
shown in figure 2.
2.
Place the balance upright on a firm, level vibration-free with the dial and
operating knob facing the operator.
3.
Place the pan holders on top of the trusses visible through the grommet openings
in the glass on the top of the balance (Figure 2). Place the pans on the pan holders.
If the balance has a scoop, it should be placed on the left-hand pan holder.
LEVELING THE BALANCE
This is accomplished by turning both leveling screw in the same direction at the
same time and in equal amounts. This will raise or lower the balance as required to bring
the bubble in the level, located on the lower right side of the case, to the center of the
vial.
ZEROING THE BALANCE
Set the dial knob to zero. Release the balance by turning the operating knob in the lower,
front center of the base counterclockwise. Bring the balance into equilibrium by means of
the leveling screws as follows: If pointer moves to the right, turn the left leveling screw
counterclockwise and the right leveling screw clockwise. The leveling screws should be
rotated simultaneously and as equally as possible. If the pointer moves to the left, turn the
left leveling screw clockwise and the right leveling screw counterclockwise.
The balance is now ready for use. If it does not operate properly, recheck the directions to
be certain that all steps have been performed. Do not attempt any adjustments you may
think necessary, other than those indicated in the instructions, without first contacting the
factory. When you are satisfied that the balance is in proper operating condition, please
complete and mail the post paid warranty card.
NOTICE
Regulations regarding the inspection of prescription balances vary from one jurisdiction
to another. To eliminate the possibility of any problems, you should, within 24 hours of
receipt of your balance, contact your local Weights and Measures office to arrange for an
inspection if it is required.
