En-11
10. TEST RUN
WARNING
Do not turn on the power until all installation work is complete.
CAUTION
When restarting after a long period of disuse in the winter, turn
the power switch on at least 12 hours before starting the unit.
Check items
(1) Is operation of each button on the remote controller nor-
mal?
(2) Does each lamp light normally?
(3) Do air
fl
ow direction louvers operate normally?
(4) Is the drain normal?
(5) Do not have an abnormal noise and vibration during op-
eration?
●
Do not operate the air conditioner in test run for a long
time.
[Operation method]
●
For the operation method, refer to the operating manual.
●
The outdoor unit may not operate depending on the room
temperature.
In this case, press the test run button on the remote controller
while the air conditioner is running.
(Point the transmitter section of the remote controller toward
the air conditioner and press the test run button with the tip of
a ballpoint pen, etc.)
●
To end test operation, press the remote controller START/
STOP button.
(When the air conditioner is running by pressing the test
run button, the OPERATION Lamp and TIMER Lamp will
simultaneously
fl
ash slowly.)
[Using the wired remote controller] (Option)
●
For the operation method, refer to the operating manual.
(1) Stop the air conditioner operation.
(2) Press the master control button and the fan control button
simultaneously for 2 seconds or more to start the test run.
(3) Press the start/stop button to stop the test run.
Transmitter section
Test run button
Test run display
11. REMOTE CONTROLLER INSTALLATION
1
CAUTION
•
Check that the indoor unit correctly receives the
signal from the remote controller, then install the
remote controller holder.
•
Select the remote controller holder selection site by
paying careful attention to the following:
Avoid places in direct sunlight.
Select a place that will not be affected by the heat
from a stove, etc.
11.1.
Remote controller holder installation
• Install the remote controller a maximum distance of 7 m
(23 ft) from the remote control receiver. However, when
installing the remote controller, check that it operates cor-
rectly.
• Install the remote controller holder to a wall, pillar, etc. with
the tapping screw.
Remote controller holder fixing
Remote controller mounting
Remote controller
holder
Tapping
screw
(small)
Remote
controller
(2) Push
(1) Set
9318739022_IM.indb Sec1:11
9318739022_IM.indb Sec1:11
2010-11-2 15:25:18
2010-11-2 15:25:18
