En-12
When two or more air conditioners are installed in a room and the remote controller is operating an air conditioner other than the one you
wish to set, change the signal code of the remote controller to operate only the air conditioner you wish to set (4 selections possible).
When two or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner signal
codes.
SELECTING THE REMOTE CONTROLLER SIGNAL CODE
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock display.
In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote controller resets to signal code A when the batteries in the remote controller are replaced. If you use a signal code
other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
) until you
fi
nd the code
which operates the air conditioner.
Selecting the Remote Controller Signal Code
Use the following steps to select the signal code of the remote controller. (Note that the
air conditioner cannot receive a signal code if the air conditioner has not been set for the
signal code.)
1
Press the “START/STOP” button until only the clock is
displayed on the remote controller display.
2
Press the “MODE” button for at least 5 seconds to dis-
play the current signal code (initially set to ).
3
Press the “SET TEMP. (
/
)” buttons to change the
signal code between
. Match the code on the
display to the air conditioner signal code.
4
Press the “MODE” button again to return to the clock
display. The signal code will be changed.
9374136131-02_OM.indb 12
9374136131-02_OM.indb 12
24/9/2553 15:18:47
24/9/2553 15:18:47
