SLR 25/50 Gbyte
4 - English
A26361-H583-Z100-1-7419
SCSI address (SELECT)
Every device on the SCSI bus must have its own SCSI address (ID). The SCSI address for the drive
is set using the SELECT jumpers (0, 1, 2 and 3).
By default, SCSI address 7 is reserved for the SCSI controller.
SELECT 0
SELECT 1
SELECT 2
SELECT 3
SCSI address
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
not inserted
inserted
inserted
not inserted
not inserted
inserted
inserted
not inserted
not inserted
inserted
inserted
not inserted
not inserted
inserted
inserted
not inserted
not inserted
inserted
inserted
inserted
inserted
not inserted
not inserted
not inserted
not inserted
inserted
inserted
inserted
inserted
not inserted
not inserted
not inserted
not inserted
inserted
inserted
inserted
inserted
inserted
inserted
inserted
inserted
not inserted
not inserted
not inserted
not inserted
not inserted
not inserted
not inserted
not inserted
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Termination/terminating resistor
The last device at both ends of the SCSI bus must be equipped with a terminating resistor. Devices
that are not connected to the end of the SCSI bus must not be terminated.
If you run the SLR drive as the last device on the SCSI bus, you must connect an active wide SCSI
terminating resistor to the SCSI interface of the drive. The active wide SCSI terminating resistor can
either already have been integrated in the SCSI cable or be connected as a separate connector.
i
The drive has no integrated terminating resistor.
Terminator Power (TPWR)
The TPWR jumper sets the power supply for the terminating resistors on the SCSI bus. The
terminating resistors can be provided with power by the drive or the SCSI bus.
TPWR jumper inserted = power supply from drive
TPWR jumper not inserted = power supply from SCSI bus
