SK-96390-100PMC User Guide
Chapter 3 Connectors
© Fujitsu Microelectronics Europe GmbH
- 21 -
UG-960017-11
3 Connectors
3.1 Power
connector
(X12)
The following figure shows the power connection jack X12. This connector is used to
connect an external unregulated DC power supply voltage (9V-15V DC) to the evaluation
board.
Connector X12:
Figure 3-1: Power Connector
3.2 MCU pin header connectors (X4A/B/C, J1 and J2)
All pins (except oscillator and supply pins) of the microcontroller are directly connected to pin
headers. Pin 1 of the MCU corresponds to Pin 1 of the connector. Pin 2 of the MCU
corresponds to Pin 2 of the connector, and so on.
3.3 CAN
Connector
(X10)
One 9-pin D-Sub male connector is used for the CAN interface CAN A.
Figure 3-2: CAN Connector
Pin Number
Pin Signal
Description
1
NC Not
used
2
CANL
LOW-level CAN voltage input/output
3
GND Ground
4
NC Not
used
5
NC Not
used
6
NC Not
used
7
CANH HIGH-level
CAN
voltage
input/output
8
NC Not
used
9
NC Not
used
Shield GND
Ground
Table 3-1: CAN Connector Signals
Shield is connected to GND (-)
Center is connected to positive voltage supply (+)
+