![background image](http://html.mh-extra.com/html/fujitsu/sk-96380-120pmc/sk-96380-120pmc_user-manual_20667014.webp)
SK-96380-120PMC User Guide
Chapter 3 Jumpers and Switches
UG-960019-11
- 14 -
© Fujitsu Microelectronics Europe GmbH
ON
OFF
DIP-Switch S1
(RUN Mode)
MD0 MD1 MD2 nc
1
2
3
4
ON
OFF
DIP-Switch S1
(Programming Mode)
MD0 MD1 MD2 nc
1
2
3
4
3 Jumpers and Switches
This chapter describes all jumpers and switches that can be modified on the evaluation
board. The default setting is shown with a grey shaded area.
3.1 Operating Mode (S1)
This switch controls the MCU operation mode after Reset.
Please take care of the following mode settings:
DIP switch
Setting
Logical value
ON (closed)
1 (high)
S1-1
(MD0)
OFF (open)
0 (low)
ON (closed)
1 (high)
S1-2
(MD1)
OFF (open)
0 (low)
ON (closed)
1 (high)
S1-3
(MD2)
OFF (open)
0 (low)
ON (closed)
Not connected
S1-4
(Not used)
OFF (open)
Not connected
Table 3-1: MCU Operating Mode
Figure 3-1: MCU mode switch: RUN mode (Fixed Vector Mode)
Figure 3-2: MCU mode switch: Flash Programming mode