System configurator and order-information guide
D
PRIMERGY TX200 S7 Status 2014-01-30
Section
III
Memory
- There are 6 memory slots per CPU for max.
96GB RDIMM (6x 16GB 2R)
24GB UDIMM (6x 4GB)
=> max. 192GB for two CPU`s ( 96GB per CPU ), using RDIMM
- The memory area is divided into 3 channels per CPU with 2 slots per channel
- Slot 1 of each channel belongs to memory bank 1, the slot 2 belongs to memory bank 2.
Registered and unbuffered memory modules can be selected
No mix of registered and unbuffered modules allowed.
Memory can be operated at 1.5V or 1.35V, even if the modules are of low voltage type.
Memory operating voltage can be set within BIOS (
1.5V is default
setting for max. speed).
In a 2 DIMMs per channel configuration, following frequencies are supported:
- 1.5V - 1600MHz max (depending on CPU, special memory modules)
- 1.35V - 1333MHz max (depending on CPU)
SDDC (Chipkill) is supported for registered x4 organized memory modules only
1.) In the "Independent Channel Mode" is following configuration possible
Channels can be populated in any order in Independent Channel Mode. All 3
channels may be populated in any order and have no matching requirements. All
channels must run at the same interface frequency but individual channels may run at
different DIMM timings (RAS latency, CAS latency, and so forth)
No mix of registered and unbuffered modules allowed.
2.) "Rank Sparing Mode" configuration
- Within a memory channel, one rank is a spare of the other ranks.
The Spare Rank is held in reserve and is not available as system memory
For the effective memory capacity, please refer to the spreadsheet below.
The BIOS is set to the rank sparing setting.
Minimum configuration is: 2x 1R, 2x 2R or 1x4R DDR3 module per channel
This mode is not supported by x8 organized memory modules
3.) "Performance Mode" configuration
- In this configuration, the memory module population ex factory is spread across all channels.
The BIOS is set to the max. performance for memory.
Minimum configuration is: 3x identical modules
4.) In the "Mirrored Channel Mode" is following configuration possible
- Each memory bank can optionally be equipped with 2x registered memory modules
In each memory bank channel B and C of CPU 1 or channel E and F of CPU 2 have to be
equipped with identical modules for mirrored channel mode.
In channel C is always the mirrored memory of channel B of CPU 1
In channel F is always the mirrored memory of channel E of CPU 2
Minimum configuration is: 2x identical modules
This mode is not supported by x8 organized memory modules
D1
Fujitsu PRIMERGY Server
11 of 28