70
Operating Manual
RX600
S6
Starting up and operation
©
c
og
ni
ta
s.
Ges
el
ls
ch
ft f
ü
r T
e
ch
ni
k-
D
ok
um
e
nt
a
tio
n m
bH
201
1
P
fad:
C:
\P
rog
ra
m
m
e\
F
C
T
\ti
m
_a
pp
\ti
m
_l
o
ca
l\w
or
k\
P
ICH
OL
\O
B
J_
D
OK
U
-1
1
93
9-
00
1.
fm
–
System already installed
:
Ê
Press the On/Off button (see
figure 8 on page 58
).
The server is switched on, performs a system test and boots the
operating system.
Switching the server off
The power-on indicator lights up green (item 5 in
figure 8 on page 58
).
Ê
Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights up orange.
I
If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other On/Off options
Besides the On/Off button, the server can be switched ON and OFF in the
following ways:
–
Timer-controlled switch-on/off
Using the ServerView Operations Manager or iRMC S2, you can configure
that the server is switched on/off controlled by timer.
–
Ring indicator
The server is switched on by an internal or external modem.
–
Wake up On LAN (WOL)
The server is switched on by a command via the LAN (Magic Packet
TM
).
–
After power failure
The server automatically reboots following a power failure (depending on the
settings in the BIOS or in iRMC S2).
–
Power button override
The system can be switched off by pressing and holding down the On/Off
button (for approximately 4 - 5 seconds).
