Fujitsu NC14004-B713, User Manual

Page: 27 / 31

24
Troubleshooting
Symptom Cause Remedy
The AC cord has come unplugged from
either the outlet or the Cat5 Extender Connect AC cord.
Cat5 cable length setting is incorrect. Reset length, using the section on
setting Cat5 cable length in this
manual as a reference.
Monitor is set to a resolution that is not
supported. Set monitor to a supported
resolution.
No image
displayed on
monitor
Server not sending image signal (in
suspend status) Input an image signal from the
server.
Improper key repeat settings At the server, change the key
repeat speed setting. Keyboard/
Mouse
functions
improperly
or not at all. Unsupported keyboard/mouse
connected
Exchange peripheral in question
with a supported
keyboard/mouse.
Poor connection/defective cable Confirm that the connector is
connected properly.
Use a different cable. If the
problem goes away, exchange the
defective cable with a good one. Poor image
quality
(Ghosts,
blurry
letters, etc.)
Cat5 cable length setting is incorrect. Reset length, using the section
setting Cat5 cable length in this
manual as a reference.
Lower resolution.
Adjust monitor
Image is not
centered on
screen. Adjust monitor.
Cat5 Extender connection terminated Check connection.
Reboot Cat5 Extender.
Cat5 Extender stopped functioning
(froze) Turn power back on.
Cat5
Extender
stopped
working
suddenly.
Error occurred at server Remedy server error.
Transmitter Audio Out has been
connected to the server line out. Connect the Cat5 Extender to the
Audio In port on the transmitter.
Cat5 Audio cable has become
detached or been connected to the
Video connector. Check connection.
Volume is set to 0. Turn volume up.
Server volume control is set to "mute". Turn off "mute" at server volume
control.
No sound
emitted.
If sound is emitted when speakers
are connected to the Audio Out
port on the transmitter, please
contact your place of purchase.