Interface
5.4 Command Protocol
The host should confirm that the BSY bit of the Shadow Block Status field of the
device is 0 prior to issue a command. If BSY bit is 1, the host should wait for
issuing a command until BSY bit is cleared to 0.
Commands can be executed only when the DRDY bit of the Status field is 1.
However, the following commands can be executed even if DRDY bit is 0.
•
EXECUTE DEVICE DIAGNOSTIC
•
INITIALIZE DEVICE PARAMETERS
Note: Each FIS type is referred to as follows in this section.
FIS (Frame Information Structure) type
Abbreviation
Register - Host to Device
RegHD
Register - Device to Host
RegDH
DMA Active - Device to Host
DMA Active
DMA Setup - Device to Host or Host to Device
(Bidirectional)
DMA Setup
Set Device Bits - Device to Host
SetDB
BIST Active - Bidirectional
BIST Active
PIO Setup - Device to Host
PIO Setup
Data - Host to Device or Device to Host (Bidirectional) DATA
5.4.1 Non-data command protocol
•
SET MAX ADDRESS (EXT)
Execution of the following commands does not involve data transfer between the
host and the device.
•
RECALIBRATE
•
SEEK
•
READ VERIFY SECTOR(S) (EXT)
•
EXECUTE DEVICE DIAGNOSTIC
•
INITIALIZE DEVICE PARAMETERS
•
SET FEATURES
•
SET MULTIPLE MODE
5-168
C141-E244
Summary of Contents for MHV2160BT
