Fujitsu MCM3064AP, Product Manual

Page: 62 / 202

Installation Requirements
3-18 C156-E227-01EN
(3) Cable selection mode setting
Figure 3.14 shows the master/slave device setting that is set by connecting the
CSEL signal line to the interface. The special interface connector shown in the
example in Figure 3.14 is also required.
5 3 1
CNH5
6 4 2
Figure 3.14 Cable selection mode setting
Figure 3.15 shows an example of cable selection with the special interface cable.
In the figure, master CSEL is connected to the cable-side CSEL line (conductor)
and then connected to GND. By this, the master drive detects itself as a master.
At the same time, the slave device detects itself as a slave because the conductor
of slave CSEL is removed and slave CSEL has no connection to cable-side CSEL.
Host system Master device Slave device
GND
Example (1)
CSEL conductor
Open
Host system Master device Slave device
GND
Example (2)
CSEL conductor
Open
Figure 3.15 Cable selection example