Starter Kit MB2146-410-01-E Setup Guide V1.1
Chapter 3 EV-board Manual
MCU-UM-500002-E-11 – Page
12
3.4.2 BGMA Interface
To start the debug using a BGMA, users shall connect IDC10 socket from the BGMA to CN1
on an EV-board, and J2 shall be open in a debug mode. In a normal (free-run) mode, J2
shall be closed to enable reset key S3. Refer to Figure 3.4.2-1.
Figure 3.4.2-1 Debug Interface
MCU Mode
Header name
Settings
Debug mode
J2
User mode
J2
3.4.3 Clock Settings
The MB95200H/210H series MCU uses an internal main RC as a clock source by default.
Users can select on-board crystal as a main clock and a sub-clock. Follow the settings below:
Clock
Header name
Settings
Main clock
SW3: X1, X0
Sub-clock
SW3: X1A, X0A
Table 3.4.3-1
3.4.4 Buzzer Module
A buzzer module is provided to demonstrate an 8/16 composite timer output (a continuous
mode). To enable buzzer module, follow the table below:
Modules
Header name
Settings
Buzzer:
BUZ1
SW1: BUZ.
Table 3.4.4-1
