Fujitsu Lifebook S760, User Manual

Page: 88 / 415

82 - Memory Upgrade Module
Memory Upgrade Module
Your Fujitsu LifeBook notebook comes with a minimum of 1GB of high speed Double Data Rate 3
Synchronous Dynamic RAM (DDR3-1066 SDRAM) factory installed. To increase your notebook’s memory
capacity, you may install an additional memory upgrade module. The memory upgrade must be a dual-in-
line (DIMM) SDRAM module. To ensure 100% compatibility, purchase the SDRAM module only from
the Fujitsu web store at www.shopfujitsu.com
.
Installing Memory Upgrade Modules
1
Turn off power to your notebook, remove any power adapter (AC or auto/airline). Remove the battery.
2
Turn the notebook bottom side up, and remove the screw from the memory upgrade module compartment.
3
Remove the cover.
4
Remove the memory upgrade module from the static guarded sleeve.
5
Align the memory upgrade module with the component side up. Align the connector edge of the module with
the connector slot in the compartment. Be sure the alignment keys line up with those in the slot.
•
D
O NOT REMOVE ANY SCREWS FROM THE MEMORY UPGRADE MODULE COMPARTMENT EXCEPT THE
ONES SPECIFICALLY SHOWN IN THE DIRECTIONS FOR INSTALLING AND REMOVING THE MEMORY
UPGRADE MODULE
.
•
T
HE MEMORY UPGRADE MODULE CAN BE SEVERELY DAMAGED BY ELECTROSTATIC DISCHARGE
(ESD). T
O MINIMIZE RISK TO THE MODULE
,
OBSERVE THE FOLLOWING PRECAUTIONS
:
-- B
EFORE HANDLING A MEMORY MODULE
,
TOUCH A GROUNDED METAL OBJECT TO DISCHARGE STATIC
ELECTRICITY BUILT UP IN YOUR BODY
.
-- W
HEN INSTALLING OR REMOVING A MEMORY MODULE
,
HOLD IT BY THE EDGE SO AS NOT TO TOUCH
ANY CONTACTS OR CHIPS
. B
E CAREFUL NOT TO TOUCH ANY INTERNAL COMPUTER TERMINALS OR
COMPONENTS
;
THE OIL FROM YOUR FINGERS COULD CAUSE A SHORT TO THE COMPONENTS
.
-- B
E SURE TO POWER DOWN YOUR SYSTEM BEFORE ADDING OR REMOVING MEMORY MODULES
. E
VEN
IF THE SYSTEM IS IN HIBERNATE OR STANDBY STATES
,
DATA COULD BE LOST OR THE MEMORY
COULD BE DAMAGED IF POWER IS STILL AVAILABLE TO THE SYSTEM
.