Fujitsu L20T-1 ECO, Getting Started

Page: 24 / 312

LCD monitor
4 - English Edition 2
Cleaning
Ɣ
Always pull out the power plug before you clean the monitor.
Ɣ Do not clean any interior parts yourself, leave this job to a service technician.
Ɣ Do not use any cleaning agents that contain abrasives or may corrode plastic.
Ɣ
Ensure that no liquid will run into the system.
Ɣ Ensure that the ventilation areas of the monitor are free.
Ɣ The display surface of the LCD monitor is sensitive to pressure and scratches. Clean it only
using a soft, slightly moistened cloth.
Wipe the monitor casing with a dry cloth. If the monitor is particularly dirty, use a cloth which has
been moistened in mild domestic detergent and then carefully wrung out.
CE marking
The shipped version of this device complies with the requirements of the EC directives
2004/108/EC "Electromagnetic compatibility" and 73/23/EEC "Low voltage directive".
FCC Class B Compliance Statement
The following statement applies to the products covered in this manual, unless otherwise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital device,
pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian Interference-
Causing Equipment Standard ICES-003 for digital apparatus. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in strict
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Ɣ
Reorient or relocate the receiving antenna.
Ɣ Increase the separation between equipment and the receiver.
Ɣ Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Ɣ Consult the dealer or an experienced radio/TV technician for help.
Fujitsu Siemens Computers GmbH is not responsible for any radio or television interference caused
by unauthorised modifications of this equipment or the substitution or attachment of connecting
cables and equipment other than those specified by Fujitsu Siemens Computers GmbH. The
correction of interferences caused by such unauthorised modification, substitution or attachment will
be the responsibility of the user.
Downloaded from ManualMonitor.com Manuals