Fujitsu IP-900D, Hardware User'S Manual, Page: 55 / 116

Chapter 2 Installation and Connection
IP-900E/IP-900D/IP-900IID
41
2.4
Connection to Network
To connect IP-900E/IP-900D/IP-900IID to a LAN device, connect the LAN device to the LAN
communication port of IP-900E/IP-900D/IP-900IID using a LAN cable (UTP cable). The LAN
communication port specification of IP-900E/IP-900D/IP-900IID is 10BASE-T/100BASE-TX.
The figure below shows the connection method.
For details about connectors and cables, see Section 4.2, “Cable and Connector Details.”
For electrical specifications, see Appendix 2.3,
“Function Specifications.”
Figure Connection to a network
Please do not provision the IP address below.
・
IP address commonly unused
（
0.0.0.0
，
255.255.255.255
，
etc…
）
・
Loop back address (127.xxx.xxx.xxx)
・
Class D and Class E addresses
・
IP address already used
For more information, see IP-900E/IP-900D/IP-900IID Software User’s Guide.
RDY
PWR ALM
IN
DWN
OPT
MNT
FG
/ACT
100M
LINK
10/100BASE RS-232C
ANALOG AUDIO IN
AN
AL
O
G
VID
EO
IN
SD
I
E
L R
100-240V
Hub, Router, PC, etc.
2.4
CAUTION
NOTE: