Change even page title here
Chapter 5 Configuration of the Evaluation-Board
UG-900001-32
- 10 -
© Fujitsu Microelectronics Europe GmbH
5 Configuration of the Evaluation-Board
The board is configured to work with the MB90F598 microcontroller.
In order to set up the board follow these steps:
1. disconnect power supply disconnected !
2. Set jumper JP1 to provide Vcc, i.e. 5V to the board
3. If case one is connecting this board to an emulator, it is recommended to set jumper JP2
in order to provide 3.7V to the internal core.
4. Please set the mode pins 1-3 on S3 according to your MCU operating mode. ON stands
for 0 and OFF for 1. E.g. MB90F598 all switches to OFF except no. 3.
5. Adjust both potentiometers (P1, P2) clockwise to their end position.
(Check that Pin 8 of U4 and Pin 8 of U5 are grounded.)
6. Select the appropriate CAN interface for the microcontroller you are using by setting
jumper JP3-JP6. Note that Pixx on the silk plot stands for Pinxx, i.e. the pin number.
E.g. for the MB90F598, set JP3 and JP4 to connect Pin 2 and 3 in order to connect to
MCU Pins 74 and 75, respectively.
CAN0
CAN1
CAN2
Target
Series
RX0
TX0
RX1
TX1
RX2
TX2
MB90425
Pin 75
Pin 74
n.a.
n.a.
n.a.
n.a.
Pin 72
Pin 71
MB90440
Pin 74
Pin 73
Pin 76
Pin 75
(Not supported by
Jumper 3-6 !)
MB90470 n.a. n.a. n.a. n.a. n.a. n.a.
MB90540
Pin 74
Pin 73
Pin 76
Pin 75
n.a.
n.a.
MB90545
Pin 74
Pin 73
n.a.
n.a.
n.a.
n.a.
MB90550 n.a. n.a. n.a. n.a. n.a. n.a.
MB90583 n.a. n.a. n.a. n.a. n.a. n.a.
MB90590
Pin 75
Pin 74
Pin 97
Pin 98
n.a.
n.a.
MB90595
Pin 75
Pin 74
n.a.
n.a.
n.a.
n.a.
Table 1: Microcontroller pin-number of the CAN-interface
