En-11
AIR CONDITIONER Wall Mounted Type
OPERATING MANUAL
Care and Cleaning
Replacing the air cleaning
fi
lter
1
Remove the air
fi
lter. (Refer to step 1 in “Replacing the air
fi
lter”.)
2
Release 2 latches
a
of the
fi
lter holder, and turn over the holder
in direction of arrow
b
.
Remove the soiled air cleaning
fi
lter
c
.
Note:
Air
cleaning
fi
lter is attached on each air
fi
lter.
a
a
b
c
3
Attach new or maintained air cleaning
fi
lter
d
to the
fi
lter holder.
New air cleaning
fi
lter can be attached to either of the right holder
or the left holder.
d
4
Latch 2 corners of the
fi
lter holder
e
to the air
fi
lter
fi
rmly.
e
e
5
Reinstall the air
fi
lter. (Refer to step 6 in “Cleaning the air
fi
lter”.)
6
Close the intake grille
fi
rmly.
(Refer to step 4 in “Cleaning the intake grille” on page 10.)
Following 2 types of air cleaning
fi
lters are used in this product.
When you replace them, purchase dedicated air cleaning
fi
lters for this
product.
Apple-catechin
fi
lter: UTR-FA16
(1 sheet)
The Apple-catechin
fi
lter uses static electricity to clean
fi
ne particles
and dust in the air such as tobacco smoke and plant pollen that are
too small to see.
• This
fi
lter is disposable. Do not wash or reuse it.
• Once you open the package, use it as soon as possible. The
cleaning effect is reduced if the
fi
lter is left with the package opened.
• Replace the
fi
lter once every 3 months under normal use.
• By setting the fan speed high, the air cleaning effect increases.
Ion deodorization
fi
lter: UTR-FA16-2
(Light blue, 1 sheet)
The
fi
lter deodorizes by powerfully decomposing absorbed odors
using the oxidizing and reducing effects of ions generated by the
ultra-
fi
ne-particle ceramic.
• To maintain the deodorizing effect, clean the
fi
lter once every 3
months as follows:
1.
Remove the
fi
lter.
2.
Flush the
fi
lter with high-pressure hot water until the surface of
the
fi
lter is covered with water.
3.
Wash the
fi
lter gently with diluent neutral detergent. Do not wash
it by wringing or rubbing to prevent reducing the deodorizing
effect by damage.
4.
Rinse the
fi
lter well with water
fl
ow.
5.
Dry the
fi
lter throughly in a shaded place.
6.
Reinstall the
fi
lter to the indoor unit.
• Replace the
fi
lter once every 3 years under normal use.
After extended non-use of the unit
If you have shut down the indoor unit for 1 month or more, perform the
FAN operation for half a day to dry the internal parts throughly before
you perform normal operation.
Additional inspection
After long period of use, accumulated dust inside the indoor unit may
reduce the product performance even if you have maintained the unit
with instructed daily care or cleaning procedures written in this manual.
In such a case, a product inspection is recommended.
For more information, consult authorized service personnel.
Filter Indicator Reset (Special setting)
• This function can be used if set correctly during installation.
Please consult authorized service personnel in order to use this
function.
• Clean the air
fi
lter when the indicator lamp show the following;
ECONOMY indicator lamp
Flashes 3 times, at intervals of 21
seconds
After cleaning, reset the
fi
lter indicator by pushing the “MANUAL AUTO”
button on the indoor unit for 3 seconds or less.
9333003283-02_OM_EN.indd 11
9333003283-02_OM_EN.indd 11
2017/11/29 10:24:12
2017/11/29 10:24:12
