3
Fig. 1 Indoor Unit
1
Operating Control Panel (Fig. 2)
2
POWER Switch
3
MANUAL AUTO button
4
Remote Control Signal Receiver
5
Indicator Lamps (Fig. 3)
6
OPERATION Indicator Lamp (red)
7
TIMER Indicator Lamp (green)
●
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 13 Auto Restart).
8
SWING Indicator Lamp (orange)
9
Intake Grille (Fig. 4)
0
Air Filter
A
Air Flow Direction Louver
B
Right-Left Louver
(behind Air Flow Direction Louver)
C
Power Diffuser
D
Drain Hose
E
Power Supply Plug
F
Power Supply Cord
G
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
H
Intake Port
I
Outlet Port
J
Pipe Unit
K
Drain port (bottom)
Fig. 6 Remote Control Unit
L
SLEEP button
M
MASTER CONTROL button
N
SET TEMP./SET TIME buttons (
)
O
Signal Transmitter
P
TIMER button
Q
FAN CONTROL button
R
START/STOP button
S
AIR FLOW DIRECTION button
T
SWING LOUVER button
Rear side (Fig. 7)
U
TIME ADJUST button
V
ACL button
(located inside battery compartment)
W
TEST RUN button
●
This button is used when installing the
conditioner, and should not be used un-
der normal conditions, as it will cause the
air conditioner’s thermostat function to op-
erate incorrectly.
●
If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit’s OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
●
To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
X
Remote Control Unit Display (Fig. 8)
Y
Transmit Indicator
Z
Clock Display
[
Operating Mode Display
\
Timer Mode Display
]
Fan Speed Display
_
Temperature Set Display
a
Timer Set Indicator
b
Temperature Set Indicator
NAME OF PARTS
●
Refer to the fold-out page on the cover.
