En-2
STANDARD PARTS
The following installation parts are supplied. Use them as required.
Name and Shape
Coupler heat
insulation
Special nut A
(large flange)
Special nut B
(small flange)
Q’ty
2
4
4
Name and Shape
Bolt
Washer
Blower cover insulation
Q’ty
4
4
2
INDOOR UNIT ACCESSORIES
GRILLE ACCESSORIES
Name and Shape
Template
Binder
Q’ty
1
2
SELECTING THE MOUNTING POSITION
•
Leave the space specified in Fig. 1 so that the air from the blower
will cover the entire room.
•
Install the indoor unit on a place having a sufficient strength so
that it withstands against the weight of the indoor unit.
•
A place from where drainage can be extracted outdoors easily.
Fig. 1
Strong and durable ceiling
250 mm (9-3/8”)
or more
1,000 mm (39”)
or more
Obstruction
Service space
1,000 mm (39”)
or more
WARNING
1
Never install in a room where there is the poten-
tial of leaking flammable gas. A spark could ig-
nite the gas and cause an explosion or fire.
2
Avoid installing in a location with high tempera-
ture.
Fig. 2
100 mm (4”)
or more
100 mm (4”)
or more
100 mm (4”)
or more
1,000 mm (39”)
or more
(4 directions)
(3 directions)
(2 directions)
(2 directions)
Pipe
•
The blower direction can be set for two directions or three di-
rections. When using two-direction or three-direction blower, fol-
low Fig. 2 for the blower direction and space.
•
The method for changing the blower direction is shown in the
“9. GRILLE INSTALLATION” section of the “INSTALLATION
PROCEDURE”.
