18
Operation
The cleaning time of cooker hood is reminded via display lamp.
If cleaning lamp lights up, please clean the disk, oil tray and other parts (refer to page 25).
After cleaning, press the cleaning lamp switch and the lamp goes out (refer to page 17).
* Initial setting of the cleaning lamp display time is [standard], change the settings in conformity with the use
frequency of the cooker hood by reference to the "setting standard".
Setting Standard
Daily using time
Settings
Setting time
Time for light on
Around 1-hour
Shortest
60-hour
Light up in around 60 days
Around 1.5-hour
Short
90-hour
Around 2-hour
Standard
120-hour
Around 3-hour
Long
180-hour
—
Removing
Cleaning lamp function relieved
Don't light it up
E.g.) according to the [standard], about 1 hour is set for running the cooker hood, and about 120 days later,
the cleaning lamp lights on. If you want to light on the lamp about 60 days later, the setting is changed
into the [shortest] to make it turning on at appropriate time.
Setting method for the display time
1) Press the on/off switch to stop running.
* Under 24 hour mode running condition, the settings can
be changed without shutdown.
2) At the same time, continue to press (about 3 seconds) the
on/off switch and the cleaning lamp switch, the cleaning
lamp under setting mode flashes.
3) Press the air flow switch and change the settings. Press the
switch every time, the setting will be switched.
Settings
The display light
Shortest
Short
Standard
Long
None
At the same time,
continue to press it
(about 3s)
The shortest
▼
Short
▼
Standard
▼
Long
▼
Removing
Note
After resetting, restart to count the cleaning time.
For the power plug of the cooker hood, keep timing since socket is pulled up. When re-clocking is done,
please operate the cleaning lamp switch or change the settings of cleaning time.
Running time does not contain 24 hour mode operation.
Under running condition (only illuminating lamp turns on and excepting for 24 hour mode operation),
cut off the power via wall button/power plug/breaker, etc., there exists error in the recorded time.
If the lamp lights on too early or too late, please modify the settings of cleaning time.
* If there is no operation for 10sec under
setting mode continuously, cancel the setting
and get back to the status before changing
the settings. If setting needs to be changed,
please reset again.
Cleaning Lamp
