11
INSTALLATION (continued)
4
Remove the fan unit.
(1) Disconnect wiring connector
coming from the fan unit.
(2) Remove 5 screws from the
fan unit.
(3) There are three screws
holding the sliding bracket
(right side); remove the
middle screw, loosen the
other two, and move the
sliding bracket so as to free
the edge of the fan unit.
FWD
Screw
2
Connector
Push with a
screwdriver etc,
and pull off.
Fan unit
1
3
Slide
Loosen
Loosen
Sliding
Bracket
FWD
1
3
2
Sliding Bracket
Fixed Bracket
(rear)
Fixed Bracket
(side)
(4) Move the fan unit forward to
free it from the fixed bracket
(rear) (
➀
).
(5) Lift the right side of the fan unit
(sliding bracket side) (
➁
).
(6) Move the fan unit to the right to
release it from the fixed bracket
(left side) (
➂
).
(7) Remove the screw securing the wire
cover for the power supply box and
remove the wire cover by sliding it in
the direction of the arrow to release
the hook.
(8) Need to connect the wires.
Wire cover
Hook
Note
Make sure not to misplace the screws
removed as they will be used later.
Note
Make sure not to lose the screw
removed from wire cover. It needs to
be used again later, after connecting
the power supply wires.
