EN-24
5
Coat the O-ring with the special grease.
To apply a uniformly thin layer of silicone
grease to the O-ring, squeeze out about
5 mm (0.2 in.) of the grease provided
with this product from the tube into a
clean plastic bag (about 10 cm (3.9 in.) ×
20 cm (7.9 in.) in size) and then knead it
thoroughly. Put the O-ring into the plastic
bag and continue kneading until the O-
ring is completely covered with grease.
The plastic bag can be used more than
once if kept clean.
6
Install the front-side O-ring (white).
For correct installation, observe the sticker
(white) inside the waterproof case.
Place the front-side O-ring on the
waterproof case beforehand to confirm
that the O-ring is not twisted.
If it is not twisted, make sure that it is
clean, with no foreign particles embedded
in it or dust stuck to it, before installing it.
O-ring (white)
O-ring (white)
If you cannot install the front-side O-ring
successfully, insert it into the four corners
first and then push the other parts into
the groove.
Maintenance
00̲F500̲Wcase.indb 24
00̲F500̲Wcase.indb 24
2011/02/18 15:57:10
2011/02/18 15:57:10
Summary of Contents for WP-FXF500
Page 2: ...JP 2 00 F500 Wcase indb 2 00 F500 Wcase indb 2 2011 02 18 15 57 03 2011 02 18 15 57 03...
Page 3: ...JP 3 O 40m 00 F500 Wcase indb 3 00 F500 Wcase indb 3 2011 02 18 15 57 03 2011 02 18 15 57 03...
Page 16: ...JP 16 00 F500 Wcase indb 16 00 F500 Wcase indb 16 2011 02 18 15 57 05 2011 02 18 15 57 05...
Page 30: ...JP 30 00 F500 Wcase indb 30 00 F500 Wcase indb 30 2011 02 18 15 57 06 2011 02 18 15 57 06...
