18
EN
Problems
Possible Causes
Solutions
The film cannot be
ejected.
1
The camera shakes or has been
dropped and the film is misaligned.
2
The film has been jammed.
1
Load a new film pack.
2
Remove both batteries and insert them again.
If this does not solve the problem, remove
the jammed film and load a new film pack.
The battery becomes
exhausted quickly.
●
The batteries are not the same type.
●
Replace both batteries with new CR2 lithium
batteries of the same brand/type.
Printed pictures
Problems
Possible Causes
Solutions
Part or whole finished
print is white.
●
The back cover was opened before you
have used up the film.
●
Do not open the back cover until you have
used up the film; otherwise, the rest of the film
may be exposed and ruined for use.
The finished print
looks over exposed.
(White in color)
1
The ambient temperature is low (below
+5°C).
2
The AE light sensor window or flash
sensor window was covered.
1
Before taking pictures, place your camera in a
warm place to bring it to room temperature.
2
Be careful not to block the AE light sensor or
flash sensor window, or so that nothing blocks
it.
The finished print
looks under exposed.
(Dark)
1
The ambient temperature is high
(above +40°C).
2
The picture was taken facing the light.
3
The flash lampface, AE light sensor
window or flash sensor window was
covered.
4
The background is too bright in
comparison with the subject.
5
The flash light did not reach the
subject.
6
The flash light reflected back from a
mirror or window glass.
1
Keep camera, film (exposed prints) away from
excessive heat (+40°C).
2
Take pictures with the light behind you.
3
Be careful not to cover the flash lampface, AE
light sensor window, or flash sensor window.
4
SELECT “
” for the shooting mode.
5
Take pictures closer than 2.7 m from the
subject.
6
Take pictures at an angle not facing the mirror
or window glass.
instax̲BO-11̲instbook̲14Lang.indb 18
2/2/2018 5:38:00 PM
