Fuji Xerox apeosport-IV 6080, Administrator'S Manual

Page: 46 / 705

2 Paper and Other Media
46
P
ape
r a
nd O
the
r M
edia
2
Loading Paper in Tray 5 (Bypass)
When printing or copying on a size or type of paper that cannot be set in Trays 1 to 4,
6 or 7, use Tray 5 (Bypass).
The following describes the procedure for loading paper into Tray 5 (Bypass). For
printings, specify the instructions using the [Paper/Output] tab in the print driver. Also
specify the type of paper to be loaded.
Important • Do not add a new stack of paper on top of the remaining paper in the tray to prevent paper
jams or any other troubles. First, remove the remaining paper from the tray, and then load
the new stack of paper.
Note • Fan the paper well before loading paper in a tray. It prevents paper from sticking to each
other and reduces paper jams.
1
Open the Tray 5 (Bypass).
Note • If necessary, pull out the extension tray.
The extension tray can be extended in
two stages. Pull out the extension tray
gently.
2
Hold the center of the paper guides and slide
them to the desired paper size.
3
Load paper with the side to be copied or
printed on facing up, inserting the paper until
its edge lightly touches against the paper
feed entrance.
Important • Do not load mixed paper types in tray.
• Do not load paper above the maximum fill
line. It might cause paper jams or
machine malfunctions.
4
Adjust the paper guides to align the edges of
the paper loaded.
5
Instruct a copy or print job.