16
For a more thorough cleaning, remove the following parts:
• The Air Cap, Fluid Nozzle, Needle, Air Diffuser and Air Divider may
be soaked in warm soapy water. Do not use solvents to soak or clean
these components.
• When reinstalling the Air Diffuser, carefully rest the Diffuser Seal
on the on the back edge of the Diffuser, this will ensure that when
installing in place, the alignment is perfect.
• There is a Locating Pin on the back side of the Diffuser. This pin
must be placed into the matching hole in the Air Divider #6, and into
another matching hole in the Gun Body. The matching hole of the
Gun Body is located at a 12 o’clock position.
NOTE: DO NOT SOAK THE WHOLE APPLICATOR IN ANY LIQUID –
THIS IS NEVER NECESSARY OR ADVISABLE.
• Remove the Fluid Knob #7, Spring #9, and Needle #8 from the rear
of the Applicator.
• At the front of the Applicator, remove Collar #1 and Aircap #2.
• Using the supplied wrench, remove the Fluid Nozzle #3. Once the
Fluid Nozzle is removed, please be careful that the Air Diffuser #4 and
Diffuser Seal #5 do not fall out of the Applicator. To prevent the air
Diffuser and Diffuser Seal from falling out when removing the Fluid
Nozzle, have the Applicator pointing upwards.
• Use the Cleaning Brush and warm soapy water to clean behind the
Fluid Nozzle #3.
4000 and 4200 T-PRO Applicators: